Fixing a snapped aluminium tube on a Lovens Explorer with a piece of copper pipe
One of the aluminium tubes on our Lovens Explorer cargo bike snapped. Some 12 mm copper pipe left over from a plumbing job made a snug sleeve.
Also available in: Nederlands · Română
What broke
Our Lovens Explorer has a set of thin aluminium tubes that hold up the rain tent. They are light, they flex, and they join with the same push-fit ferrules you know from a camping tent. One of ours snapped clean through, just above the bend at the bottom.
You cannot glue a thin-walled aluminium tube that has broken like this. The two ends no longer sit straight against each other, and every gust of wind works on the joint. So it was either a new part or a splint over the break.

Why not just order the part?
I did not want to wait. A replacement means finding the right dealer, waiting out the lead time and paying for what is essentially a metre of tube, and meanwhile the tent is down and it is raining.
The sleeve
A broken tube gets a splint on the outside, which is about the oldest fix there is. The sleeve takes over the bending load, so the aluminium inside only has to stay put.
I had a leftover piece of 12 mm copper pipe (outer diameter) from a plumbing job. Standard 12 mm copper has a 1 mm wall, which leaves 10 mm inside, and the aluminium tube is about 10 mm. It slides over with almost no play: snug enough not to rattle, loose enough to get on without a hammer.
- Cut a piece of copper pipe about 20 cm long. A pipe cutter gives a clean end, but a hacksaw will do. Deburr the inside edge with a round file or the back of a knife, or it will score the aluminium as it slides on.
- Clean up the two broken ends of the aluminium tube and take the burrs off, so they slide into the copper instead of catching.
- Slide the sleeve over one half, then feed the other half in from the other side until the break sits roughly in the middle of the copper.
- Drip a bit of superglue into the gap between the copper and the aluminium. That keeps the sleeve in place.
- Wrap a few turns of electrical tape where the copper meets the aluminium at the lower end. It stops the sleeve creeping down the tube and covers the edge so it cannot chafe the tent fabric.



A word on copper against aluminium
If you copy this, know that copper and aluminium touching each other in the wet form a galvanic couple, and the aluminium is the one that corrodes. On a tent bow that lives under a fabric cover and dries out between showers, that does not worry me. On a part that sits wet all year, such as a frame member or anything near the wheels, I would use a stainless or aluminium sleeve instead, or at least put a layer of tape between the two metals.
This is a splint for a tent pole. I would not do it to anything that steers, brakes or carries the children.
Does it hold?
So far, yes. The joint is stiffer than the original tube, so that bow flexes slightly less than the one on the other side. Once the fabric is on you do not notice. It cost nothing, since everything was already in the house, and took well under half an hour, most of it filing.
Parts and tools
| Item | Note |
|---|---|
| Copper pipe, 12 mm, ~20 cm | leftover from a plumbing job; any DIY shop sells it by the metre |
| Superglue | a few drops |
| Electrical tape | a few turns |
| Pipe cutter or hacksaw | |
| Small round file | for deburring both metals |